|
|
|
 |
|
Attaching Cymbals
- Remove the wing nut and top felt washer from the tilter leaving the plastic sleeve and bottom felt washer as shown (Fig. 11a). Make sure that the plastic sleeve is in good condition to protect the cymbal. If not, replace it immediately with a new one.
 |
|
|
|
- Place the cymbal, bell side up, over the tilter peg and onto the bottom felt washer. Replace the top felt washer and wing nut. Allow the cymbal to move freely for best sound. Tilt the cymbal to your preference (Fig. 11b).
|
|
|
 |
Boom Stand Assembly
2002 Export Select ELX and Export EX drumsets are equipped with the BC-800W convertible boom stand.
- Assemble the base, middle, and top sections of the BC-800W in the same manner as the C-800W cymbal stand.
- The boom arm can be attached like a boom stand as shown in (Fig. 12a).
|
- Or as a cymbal stand as shown in (Fig. 12b).
|
|
|
|
|
|
| |
| |
©1995 - 2003 Pearl Corporation. All rights reserved.
All material on this Web Site, including text, photographs, graphics, code and/or
software, are protected by international copyright and trademark laws.
Unauthorized use is not permitted. You may not modify, copy, reproduce, republish,
upload, post, transmit or distribute, in any manner, the material on this Web Site.
|
