|
Adams
Voyager Frame Assembly Instructions -for Artists, Concert,
and Soloist Series Mallet Instruments
- Connect
middle connection rods.
- Insert
wheel legs into height adjustment. (Artists Series - locking
wheels should be on audience side, non-locking wheels
on player side.)
- Connect
all four angle supports to wheel legs.
- Insert
Y bars into height adjustment. (Loosen butterfly wing
screws, turn handles clockwise to raise or counter clockwise
to lower until desired height is achieved. Tighten butterfly
wing screws.)
- Attach
large and small end pieces to Y bars.
- Insert
rails #2 and #3 into end pieces (Rail #1 is closest to
player). (If applicable, connect rails at middle point
via the rail support/stabilizer pin.)
- Concert/Soloist
- unfold resonators, clamp at mid point using attached
clamp, and insert into resonator slots on end pieces.
Lower resonator setting is for normal temperature environments.
Higher resonator setting is for warmer temperatures -
i.e. outdoors in the summer.
Artists 4.3 - unfold resonators, clamp at mid point
using attached clamp, attach H bracket to low end, and
insert into resonator slots on end pieces.
Artist 4.6 & 5.0 - unfold resonators, clamp at
mid point using attached clamp, attach bass ends-be sure
bottom resonator slides into lower rubber slot, and insert
into resonator slots on end pieces.
- Insert
rails #1 and #4 into end pieces. (If applicable, connect
rails #1/#2 and #3/#4 at middle point via the rail support
/stabilizer pin.)
- Apply
natural bars. Connect end springs.
- Apply
accidental bars. Connect end springs.
- Tighten
all wing screws. Similarly, periodically, check wing screws
are tight.
- Height
Adjustment Operation: loosen butterfly wing screw, turn
handle clockwise to raise or counter clockwise to lower
until desired height is achieved. Tighten butterfly wing
screw.
- Enjoy
your new instrument!
 |
 |
|
